4/11/2023 0 Comments Lpc1114 serial boot loader for mac![]() ![]() I used another Launchpad board and tried to configure it as a programmer starting from scratch. ![]() However, my problem seems to be more fundamental. I very likely was doing something wrong in trying to upload the second program. Any suggestions would be greatly appreciated. I'm pretty much dead in the water since I require the Serial Bootloader to program my target card. However, TM4C Serial Bootloader is nowhere to be found today. This worked last week when I loaded a previous version of the software. I did first use the LMFlash Programmer Debug Port Unlock funct6ion before trying to use the launchpad. This device does not show up anywhere in the device manager and the RED LED is not illuminated. However, the PC does not re-enumerate for the device "TM4C Serial Bootloader". All seems to go OK and the command window indicates that the upload succeeded. However, today when I went to use the program the process failed when I attempted to upload the application image (see page 25 of the application note). I have been using the Serial Boot loader and an EK-TM4C123GXL launchpad to implement a programmer for my target hardware. Other Parts Discussed in Thread: EK-TM4C123GXL, TM4C123GH6PM, TM4C123
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |